LM-WDS10 is security isolation type 1-10V dimmer, the maximum load power is 800W, the load current is 5A and 10A, within the scope of the power and the current, maximum support parallel connection 20PCS 0/1-10V led driver together, ETH-8008U+ support infrared remote control function.

LM-WDS10 has two kind of connection mode:
1). LED 1-10V driver AC input connect to mainly electricity grid, cross dimmer. this kind of connection mode is dimmer don't pick up the load, without considering load power and load current, only need to consider of the dimming current does not exceed 300mA, then can maximum parallel connect 20PCS adjustable led power driver. But this kind of connection mode, if use in 1-10V adjustable driver or not standard signal 0-10V adjustable driver, then will cannot switch off the light, need to add a extra switch in front of the dimmer to shut off.
2). Another is led driver AC input by dimmers power supply, this kind of connection mode, need to consider of the load power and load current, dimmers maximum load of 800W, current maximum 10A.

1. General information
LM-WDS10 is a security isolated 0/1-10V intelligent dimmer for LED lighting brightness adjusting, and with manually knob adjusting and IR wireless remote adjusting optional. It suitable to control the LED dimming driver and electronic rectifier which based on 0/1-10V dimming signal, to adjust the brightness of the LED lamp or fluorescent lamp, etc. It has grey scale level 256, with scheduled shut down (1-4 hours), brightness hot key and fixed gray output functions.

2. Specifications

* Max load power:        800W
* Supply voltage:         AC90-240V  50/60Hz
* Output:                     1 channel
* Circuit design with security isolated, for protect load be safety.  
* Switch Max current:  10A
* Dimming current:      < 300mA      
* Adjust the voltage and current: 10%-90%
* Dimming range:        0-100%, no frequency glisten
* Control mode:           Manually and IR remote
* Dimming voltage:      0-10V
* Scheduled shut down: 1-4 hours
* Remote distance:     10M
* Compatible above 90% led driver which based on standard 0/1-10V dimming signal

3. Installation and use instructions

* The input voltage of this controller should to be AC90 -240V.
* Never connect two wires directly in case of short circuit.
* Knob operation: Rotary knob clockwise to increase brightness, knob counterclockwise rotation will decrease the brightness.
* Remote control operation: First use, please take out the lucid spacer which under remote down side, the remote control facing the infrared receiver, ensure that there are no obstructions between
remote controller and receiver, when dimmer receives an effective signal from the infrared remote control, the light on the upside flickers.  Long press “+" and “-" can be fast dimming
 

Notice:
Please touch the motherboard while dimmer is connecting to AC power, and setup must according technical guide.